66.A.45 sets requirements for aircraft-rating endorsement, including type, manufacturer-subgroup, full-subgroup and group ratings as applicable. Training, evaluation, practical experience and first-type on-the-job training (OJT) depend on the licence category and the route; they are not one universal cumulative package.
Required aircraft ratings and conditions for exercising privileges
The licence needs the relevant aircraft rating required by 66.A.45(a), which may be a type, manufacturer-subgroup, full-subgroup or group rating, or the specified B3 or L rating. Category A requires no aircraft rating, subject to 145.A.35. A licence or rating alone does not remove the conditions in 66.A.20(b) for exercising privileges, or the requirements for the relevant maintenance-organisation authorisation.
Before exercising privileges within a group or other endorsed rating, the holder must comply with 66.A.20(b). This includes the applicable recent-experience requirement or the alternative of meeting the provision for issue of the privileges, adequate competence, and the ability to read, write and communicate at the required level in the language of the technical documentation and procedures, as well as holding the applicable organisation authorisation.
Group 1 aircraft and Appendix III type training
For Group 1 aircraft, the appropriate aircraft type-rating route applies. Appendix III type training consists of theoretical training and examination and, except for Category C, practical training and assessment. It may be conducted by an appropriately approved Part-147 organisation or by another organisation directly approved by the competent authority. A manufacturer or type-certificate holder is not automatically an approved provider merely by that status. The separate new-type manufacturer route under 66.A.45(da) is described below. Whether an aircraft is in Group 1 must be determined using all the criteria in 66.A.5, not just a 'complex' label.
Route-specific requirements, such as those of 66.A.45(da), must be checked separately.
The theoretical element covers the aircraft systems, structure, and powerplant.
The practical element involves hands-on tasks representative of the maintenance that certifying staff will be authorising.
The practical experience must include a representative cross-section of maintenance activities relevant to the type.
For the Appendix III training route, theoretical training and examination, and practical training and assessment where required, must each have been started and completed within the three years preceding the application for the rating endorsement. Differences training has its own three-year window: it must be started and completed within the three years preceding the application for the new rating. This is not a deadline three years after course completion.
Group 2 and Group 3 aircraft
For Group 2 and Group 3 aircraft, the process can be simpler.
66.A.45(e) and (f) provide group and subgroup routes with category-specific conditions. For Group 2 manufacturer subgroup ratings on B1 and C licences, the type-rating requirements must be met on at least two representative aircraft types from the same manufacturer; for full subgroup ratings, on at least three representative types from different manufacturers. B2 and B2L holders use representative practical experience relevant to the category, the subgroup and, for B2L, the applicable system ratings. The derogations remain available: a B2 or B2L holder endorsed with full subgroup 2b may be endorsed with full subgroup 2c, and a B2L holder endorsed with full subgroup 2a or 2b may be endorsed with Groups 3 and 4. The practical-experience requirements for Groups 3 and 4 and the limitation requirements for the B1 Group 3 rating must also be applied.
Practical experience and on-the-job training
Practical experience requirements for type endorsement vary by licence category.
For a first type endorsement outside Category C, 66.A.45(c) requires satisfactory completion of the corresponding OJT, subject to its provisions on gas-airship approval and on operational suitability data (OSD) for non-conventional aircraft. Under the Group 2 and 3 evaluation alternative in 66.A.45(d), B1 and B2 applicants must also demonstrate a representative cross-section of category-relevant practical experience on the aircraft type.
For licences other than Category C, the first type endorsement in the relevant category or subcategory requires satisfactory completion of the corresponding OJT under 66.A.45(c), unless the applicable derogating route provides otherwise. Appendix III governs that OJT, except OJT for gas airships, which is directly approved by the authority. For aircraft referred to in 66.A.3(b), whether the OJT counts for the first rating in the relevant (sub)categories depends on the OSD; otherwise, the condition of additional OJT for the first type rating of an aircraft referred to in 66.A.3(a) applies. It is not merely an optional common method.
For Category C applicants qualified through the academic route under 66.A.30(a)(5), two separate rules apply. Point 1(a)(iii) of Appendix III requires the first relevant theoretical type training to be at B1 or B2 level; this has applied since 6 January 2015 (Regulation (EU) No 1321/2014). For the Group 2 and 3 evaluation route, 66.A.45(d) requires the first relevant type evaluation to be at B1 or B2 level; this has applied since 12 June 2024 (Commission Implementing Regulation (EU) 2023/989). These are route-specific requirements, not a new universal duty to complete both a training route and a separate evaluation route.
Plan the required training, experience and OJT against their actual windows, counted back from the application. Point 5(d)(2) of Appendix III requires the type evaluation to be passed and the required practical experience completed within the three years preceding the application. Point 6.1(d) of Appendix III requires OJT to start and finish within the three years preceding the application for the first type rating, with at least 50% of its tasks taking place after the theoretical type training is completed.
Other type-rating routes
Under 66.A.45(da), and only in the first 30 months after a new aircraft type receives its type certificate, a rating may be endorsed on the basis of complete manufacturer training, including on-site practical training, and only when it is not the first type in that category or subcategory. The training level and duration must meet the objectives of points 5(a) to (c) of Appendix III, the training must cover the required maintenance data at the proper knowledge level and scope, and it must be confirmed by a final report from a responsible person of the manufacturer. This is a conditional alternative, not general authority for any type-certificate holder's course.
For Group 2 and 3 type evaluation, 66.A.45(d) derogates from the normal training and OJT route. Section 5 of Appendix III requires a practical assessment and an oral examination by an appropriately approved Part-147 organisation or the competent authority, addressing the specified objectives on maintenance, documentation and tooling. It permits at most three attempts in 12 months, with a 30-day wait after the first failure and a 60-day wait after the second; applicants declare their attempts and providers check them. At least one examiner must be present, and the examiner or examiners must not have been involved in the applicant's training. A written, signed report explaining the pass or fail result must be made available to the candidate, and the three-year application window for the evaluation and practical experience applies. This examiner restriction, specific to type evaluation, is distinct from the general permission to combine personnel roles in 147.A.105(e).
OJT eligibility, supervision and records
Before OJT starts, the licensing authority must accept the task list and programme. OJT must take place at one or more maintenance organisations appropriately approved for that type, with one of them controlling it. The applicant must already hold an A, B or L5 licence, or have completed the theoretical type training and at least 50% of the applicable basic experience. Qualified mentors supervise on a one-to-one basis. Applicants sign off each task with reference to an actual job card or work sheet, and mentors verify and countersign, assuming the appropriate support-staff or certifying-staff responsibility.
Mentors and assessors must meet the licence, category or type, experience and training conditions in point 6.4 of Appendix III. Mentors need at least one year holding the relevant category or type qualification and the necessary organisational release or sign-off privileges. Final assessors need at least three years in the same category with the same or a similar type, and experience or training in assessment. The rule permits the ICAO-compliant licence alternative it states, where acceptable to the authority; this is an EASA acceptance route, not a finding about any other jurisdiction's own law. Assessors must not have mentored the applicant; where an assessor took part in performing the OJT, an independent observer must attend the assessment. The OJT logbook and the final report attest completion and support the licence application, and the maintenance organisation retains the records under procedures agreed with the authority.
Differences training, limitations and when the rules apply
66.A.45 also sets out the full families of ratings, the experience-related limitations for Group 3, B3 and L ratings, and the group and subgroup derogations. Differences training also requires the appropriate rating for the starting type, or completed training on the starting type, and the applicable theoretical and practical differences requirements. Aircraft-specific OSD, direct approvals and individual qualification evidence must be checked for the actual applicant before approval.
The three-year window for the training route and the Category C academic-route theoretical-training provision have generally applied since 6 January 2015 (Regulation (EU) No 1321/2014); they were not newly introduced by Commission Implementing Regulation (EU) 2023/989. The current provisions on differences training, type evaluation and OJT have applied since 12 June 2024 (Commission Implementing Regulation (EU) 2023/989). 66.A.45(c) and the manufacturer route in 66.A.45(da) have applied in their current form since 13 February 2026 (Commission Implementing Regulation (EU) 2025/111).
Part 66 Training
Working towards your Part 66 licence?
Sofema's Part 66 Foundation course walks you through the full licensing framework — categories, modules, experience requirements, and the path to certification.
View Part 66 course